1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 43
1 TROUBLESHOOTING FOR THE HARDWARE
Misfeed when making copies or prints (using the MPT)
1
Clear the paper misfeed following the guidance shown on the touch panel. Then close
all the covers.
2
Press [YES] when “Cancel print job?” appears.
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper on the MPT with that corresponding to the size set in the
equipment after the paper misfeed is cleared. Then if you press [NO] in step 2, the job can be restarted. In this
case, it is not necessary to follow step 3 and later.
3
Place the paper on the MPT and set the paper size.
4
Try copying or printing again.
Misfeed when printing from the FAX
1
Pull out the tray in which paper misfeeds occurred
and remove all the paper from it.
If such paper misfeeds occur although [AUTO (mm)] or [AUTO (inch)]
has been selected as the paper size, this is caused by the incorrect
size detection of the paper placed in the tray. In this case, do not
remove the paper and proceed to step 3.
2
Place the paper corresponding to the set size in the
tray.
To Next Page
Loading...