33
Problem:
I am continuing to have paper exit jams.
Solution:
If you are using front feed, make sure that the front of the printer is flush with the edge of
the table.
If you are using rear feed, make sure that the rear of the printer is flush with the edge of
the table.
If you are switching paper paths on a regular basis, use a table/support for the printer
which is close to the front-to-back depth of the printer so that both the front and rear of
the printer can be placed flush with the edge of the support.
Problem:
The front access door won’t close properly.
Solution:
Make sure that the front-feed tractor covers are properly closed.
To Next Page
Loading...
