9 - English
6. Accidental release measures
7. Handling and storage
8. Exposure controls/personal protection
Exposure Guidelines
Other information
The results obtained from Chronic Toner Inhalation Study
demonstrated no lung changes in rats for the lowest (1mg/m3)
exposure level (the level most relevant to potential human exposure).
A very slight degree of fibrosis was noted in 25% of animals at the
middle (4mg/m3) exposure level, while a slight degree of fibrosis was
noted in all the animals at the highest (16mg/m3) exposure level.
These findings are attributed to "lung overloading", a generic
response to excessive amounts of any dust retained in the lungs for a
prolonged period. This study was conducted using a special test toner
to comply with an EPA testing protocol.
Biological standards
This product, as supplied, does not contain any hazardous materials
with biological limits established by the region specific regulatory
bodies.
Occupational Exposure Controls
Personal Protective Equipment
9. Physical and chemical properties
Consumer
use
Health
Hazard
Flammability Stability Special
Hazard
010None
Bulk
Packaging
Health
Hazard
Flammability Stability Special
Hazard
030None
Personal precautions Avoid breathing dust.
Environmental
Precautions
No special environmental
precautions required.
Methods for
Containment
Prevent dust cloud.
Methods for cleaning
up
Prevent dust cloud. Sweep up or
vacuum up spillage and collect in
suitable container for disposal.
Use non-sparking tools and
equipment.
Other information See Section 12 for additional
information.
Advice on safe
handling
Handle in accordance with good
industrial hygiene and safety
practice.
Prevent dust cloud.
Technical measures/
Storage conditions
Keep container tightly closed in a
dry and well-ventilated place.
Store at room temperature.
Hygiene measures None under normal use
conditions.
Industrial User Do not eat, drink or smoke when
using this product.
Wash hands before eating,
drinking, chewing gum, using
tobacco, or using toilet.
Wash hands before breaks and at
the end of workday.
Provide regular cleaning of
equipment, work area and
clothing.
Product Information
ACGIH TLV TWA 10 mg/m3 (inhalable particles)
ACGIH TLV TWA 3 mg/m3 (respirable particles)
OSHA PEL TWA 15 mg/m3 (total dust)
OSHA PEL TWA 5 mg/m3 (respirable dust)
Engineering Measures None under normal use
conditions.
Industrial use Avoid dust formation.
Ensure all equipment is
electrically grounded before
beginning transfer operations.
Provide appropriate exhaust
ventilation at places where dust
is formed.
Consumer use These recommendations apply to
the product as supplied.
Respiratory
protection
No special protective equipment
required.
Eye/Face Protection No special protective equipment
required.
Skin and body
protection
No special protective equipment
required.
Hand Protection No special protective equipment
required.
Industrial use In case of insufficient ventilation:
Wear protective eyewear
(goggles).
Effective dust mask.
Appearance Powder
Odor Faint
Odor Threshold Not applicable
Physical State Solid
pH Not applicable
Color Black
Flash Point Not applicable
Boiling Point/Range Not applicable
Softening Point 49-60°C / 120-140°F
Autoignition
temperature
Not applicable
Flammability Limits in
Air
Not applicable
To Next Page
Loading...
Need help?
General
