To Next Page
K
Katherine ContrerasSep 18, 2025
What to do if forms are loaded with their left holes out of line with the right ones on Oki Printer?
- JJames AllenSep 18, 2025
Load forms with their left holes in line with the right ones.
What to do if forms are loaded with their left holes out of line with the right ones on Oki Printer?
Load forms with their left holes in line with the right ones.
How to resolve cut sheet paper jam in Oki ML1190 Printer?
To resolve a cut sheet paper jam in your Oki printer: Turn the power off. Remove the access cover. Set the Paper Thickness lever to the Replace Ribbon position. Remove the ribbon cartridge. Move the Print Head away from the paper. Rotate the Platen Knob and pull the cut sheet out. Use tweezers if needed. Insert a folded sheet from the Paper Tray and turn the Platen Knob to push out any remaining fragments. Replace the ribbon cartridge and the Access Cover. Turn the power on.
What to do if continuous forms are jammed in Oki ML1190?
To clear jammed continuous forms in your Oki printer: Turn the power off. Tear off any unprinted forms. Remove the Input Tray and Rear Cover together. Raise each Pin Tractor cover and remove the forms from the Pin Tractors. Rotate the Platen Knob and remove the forms from the front of the printer. Place two or three forms in a stack on the Pin Tractors and turn the Platen Knob to push any remaining fragments out of the printer. Replace the Input Tray and Rear Cover. Turn the power on.
What to do if my Oki ML1190 has no power?
If your Oki printer has no power, first check that the power cable is properly connected to both the power outlet and the printer. If the connection is secure, plug another appliance into the same outlet to rule out a power outlet issue or outage.
What happens when paper feed operations for both cut sheets and continuous forms are actuated on Oki ML1190?
If paper feed operations for both cut sheets and continuous forms are actuated on your Oki printer, eject the cut sheet.
How to fix Oki Printer when there is no continuous forms feed?
If there is no continuous forms feed on your Oki printer, set the Paper Type lever to continuous forms mode.
What to do if the left and/or right margins are not correctly selected on my Oki ML1190?
If the left and/or right margins are not correctly selected on your Oki printer, reselect the left and right margins correctly in the application.
What to do if several blank lines appear in the printout when using continuous forms with Oki ML1190?
If several blank lines appear in the printout when using continuous forms with your Oki printer, cancel tear-off perforation spacing.
How to resolve Oki ML1190 issue with paper has run out?
If your Oki printer indicates that the paper has run out, simply add paper and press the SEL button.
How to fix Oki ML1190 Printer when the print carriage does not operate?
If the print carriage on your Oki printer isn't operating, it might be due to contamination on the carriage shaft. Clean any paper dust and contamination from the carriage with a dry cloth.
General| Type | Dot Matrix Printer |
|---|---|
| Resolution | 360 x 360 dpi |
| Number of Pins | 24 |
| Printing Method | Impact |
| Interface | USB, Parallel |
| Paper Handling | Tractor feed |
| Print Width | 80 mm |
