Oki ML1190 - Buttons

ML1120/ML1190 User’s Guide - Operating instructions > 46
buttoNs
BUTTON STATUS FUNCTION
SEL On-line Sets the printer to off-line.
Off-line Sets the printer to on-line and disalarms
the printer.
LF/FF On-line and off-line Feeds paper by one line. Holding the
button down results in continuous form
fed until first line of next page.
LOAD/EJECT
On-line and off-line
Continuous Forms
mode
Feed paper if it is not fed.
If the continuous form is in position, press
to retract the form to the Pin Tractors.
(If the sprocket holes of the last page of
the form disengage from the sprocket
pins, do not attempt to eject the paper as
a paper jam may result.)
On-line and off-line
Cut sheet manual mode
Ejects the cut sheet
TEAR On-line and off-line
Continuous Forms
mode
Delivers the continuous form to the cut
position. If the button is pressed again or
data is received, the original form position
is restored.
On-line and off-line
Cut sheet manual mode
Ineffective
SEL+POWER
ON Switch
Enters menu mode.
LOAD/
EJECT+SEL
On-line and off-line Microfeed down 0.18 mm (1/144 in)
for ML1120 and 0.14 mm (1/180 in) for
ML1190 step.
LOAD/
EJECT+LF/FF
On-line and off-line Microfeed down 0.18 mm (1/144 in)
for ML1120 and 0.14 mm (1/180 in) for
ML1190 step.
TEAR+SEL On-line and off-line Microfeed down 0.18 mm (1/144 in)
for ML1120 and 0.14 mm (1/180 in) for
ML1190 step at tear-off position only.
TEAR+LF/FF On-line and off-line Microfeed down 0.18 mm (1/144 in)
for ML1120 and 0.14 mm (1/180 in) for
ML1190 step at tear-off position only.
SEL+TEAR On-line and off-line Quieter print mode
Each press of the button pair progresses
the printer through Quieter print mode
> High multipart print mode
> Normal print mode
(Effective only for ML1120)