ML1120/ML1190 User’s Guide - Operating instructions > 64
iNitialisiNg meNu settiNgs
To restore the menu settings to their initial values, carry out the steps
below.
NOTE
The values adjusted by the Adjustment menus are not initialised by
the following procedure.
1. Set the Power Switch to OFF.
2. Press and hold down the SEL and LF/FF buttons together and
then set the Power Switch to ON.
MENU ITEM FUNCTION SETTING
Serial I/F Parity Set parity.
None
Odd
Even
Ignore
Serial Data 7/8
Bits
Set serial data length.
8 bit
7 bit
Protocol Set protocols.
DTR
X-ON/X-OFF
DTR & X-ON/X-OFF
Diagnostic Test Set/Cancel loop testing of
the serial interface.
No
Yes
Baud Rate Set the transmission
speed of the serial
interface.
9,600 bps
4,800 bps
2,400 bps
1,200 bps
600 bps
300 bps
19,200 bps
DTR Signal Set whether to switch
the DTR signal of the
serial interface by Select/
Deselect or hold it after
power-on.
Ready on Power UP
Ready on Select
Busy Time Set the minimum time it
takes to switch from a busy
state to a ready state.
0.2 sec
1.0 sec
To Next Page
Loading...
