ML1120/ML1190 User’s Guide - Troubleshooting > 72
resPoNdiNg to alarm coNditioNs
Use the following table for guidance on how to respond to indicated
alarm conditions.
INDICATOR ALARM MEANINGS AND ACTIONS
SEL
ALARM
OFF ON Paper has run out. Add paper and press the SEL button.
OFF Flashing The Paper Type lever is wrongly set for the type of paper in
use. Press the SEL button and set the Paper Type lever to
the correct position.
OFF Flashing Problem with cut sheet feeding. Remove the cut sheet.
OFF Flashing Print data is received but printing does not start because no
paper is being fed. Insert paper.
Flashing Flashing Printing cannot be resumed at this stage. Turn the power
OFF, verify that the carriage moves properly, then turn the
power ON again.
If the problem is still there after you turn the power ON
again, contact your dealer.
resPoNdiNg to geNeral Problems
Use the following table to help you to identify symptoms with possible
causes and take suggested remedial actions.
PROBLEM CAUSE ACTION
No power
No power The power cable is not
properly connected.
Check the power cable is
properly connected at both
power outlet and printer.
Power outlet problem or
power outage.
Plug another appliance into
this outlet to check if it works.
No printing takes place
SEL indicator is unlit. The printer driver is not
installed properly.
Re-install the printer driver
correctly.
The printer has just
stopped printing.
Press the SEL button.
There is no paper in the
printer.
Load paper.