Oki V40A-PHS - Picture Zoom and Reset; Store Picture Settings; Sound Menu Options; Volume and Balance Control

English - 43 -
Main Menu
Channel List
Installation
Configuration
Timers
TV Setup
Common Interface
Detailed information for all menu items is in Analogue
TV Menu System section.
Common Interface
• Press “M” button to display the Main Menu and use
the
or buttons to highlight the “Common
Interface”
line and press “SELECT” button.
Main Menu
Channel List
Installation
Configuration
Timers
TV Setup
Common Interface
It is required to subscribe to a pay channel company
to view the pay channels of the Digital Terrestrial broad-
casting. Obtain the Conditional Access Module (CAM)
and the Viewing card by subscribing to a pay chan-
nel company, then insert those to the Television using
the following procedure.
1. Switch off the TV and unplug from the mains.
2. Insert the CAM, then Viewing Card to the
slot that is located in the terminal cover at the
left-hand side of the TV (from front view).
• The CAM should be correctly inserted, it is impos-
sible to insert fully if reversed. The CAM or the TV
terminal may be damaged if the CAM is forcefully
inserted.
3. Connect the TV to the mains supply, switch
on and then wait for few moments until the
card is activated.
• Some CAMs may require the following set up. Please
set the CAM by entering the IDTV menu, Common
Interface then pressing “SELECT” button. (CAM set
up menu is not displayed when it is not required.)
Analogue TV Menu System
Picture Menu
PICTURE
Mode
Contrast
Brightness
Sharpness
Colour
In picture menu if PC,YPbPr, HDMI modes are se-
lected, resolution information is displayed at the
bottom of the menu osd.
Mode
By pressing

/

button, select Mode. Press

/

button to choose from one of these options: Cinema,
Dynamic
and Natural.
Contrast/Brightness/Sharpness/Colour/Hue
By pressing

/

button, select the desired Option.
Press

/

button to set the level.
Hint: Hue is displayed in picture menu when the TV
receives an NTSC signal.
Colour Temp
• By pressing

/

button select Colour Temp.
• Press

/

to choose from one of these options:
Cool, Normal and Warm.
Noise Reduction
By pressing

/

button select Noise Reduction.
Press

/

to choose from one of these options: Low,
Medium, High
or Off.
Film Mode
Films are recorded at a different number offrames
per second to normal television programmes.
By pressing

/

button, select Film Mode.
Press

/

button to set this feature On or Off. Turn
this feature on when you are watchingfilms to see
the fast motion scenes clearly.
02-ENG-40780W-1055UK-40 INCH 17MB22 PEU IDTV-(3D PANORAMA-1HDMI-BASIC PIP)(C2)-50129279.p6510.06.2008, 10:5043