Oki V40A-PHS - PC Mode Menu System; PC Picture and Position Menus; PC Picture Alignment Controls; PC Audio Input Setup

English - 48 -
Channel
Channel can be changed by “ ” / “ ” button or Digit
Buttons.
Colour System
By pressing

/

button, select Colour System.
Press “
” / “ ” button to change the colour system
to PAL, SECAM, PAL60 or AUTO.
If Sound System is set to I, SECAM is not available for
the Colour System.
Note: In EXT mode, you can choose NTSC 3.58 and
NTSC 4.43 as well.
Sound System
By pressing

/

button, select Sound System.
Press “
” / “ ” button to change the sound system
to BG, I, L, L’, DK.
Fine Tune
By pressing

/

button, select Fine Tune. Press
“
” / “ ” button to adjust the tuning.
Search
By pressing

/

button, select Search. Press “ ”
/ “
” button to start program searching.You can also
enter the desired frequency via digit buttons when
search item is highlighted.
Store
By pressing

/

button, select Store. Press
“
”or “OK” button to store the adjustments. “Stored...”
will be displayed on the screen.
Install menu in AV modes
The following screen appears in the install menu:
INSTALL
Colour System
VCR
Store
Colour System
By pressing

/

select Colour System. By press-
ing “
” / “ ” button, you can change the colour
system to
PAL, SECAM, PAL 60, NTSC 4,43, NTSC
3,58 or AUTO.
VCR
By pressing

/

select VCR. By pressing “ ” /
“
” button, you can set the VCR to ON or OFF..
Store
By pressing

/

button, select Store. Press
“ ”or “OK” button to store the adjustments. “Stored...”
will be displayed on the screen.
Source menu
By pressing “ ” / “ ” button, select the fifth icon.
Source menu appears on the screen.
SOURCE
TV
EXT-1
EXT-2
FAV
DTV
In source menu, highlight a source by pressing

/

button and switch to that mode by pressing “ ”
or “OK” button. Source options are; TV, DTV, EXT-1,
EXT-2, FAV, HDMI, YPBPR and PC.
Note: You can mark desired source options by press-
ing OK button. Therefore, when
AV
button is pressed,
only the marked source options will be available.
PC Mode
Installation
• Power off both Computer and Display before making
any connections.
• Set your PC’s resolution correctly before connect-
ing to the TV. See the table on Appendix page.
• Use 15-pin display cable to connect a PC to the LCD
TV.
Note: PC menu will not be active for TV sets without
a PC input.
02-ENG-40780W-1055UK-40 INCH 17MB22 PEU IDTV-(3D PANORAMA-1HDMI-BASIC PIP)(C2)-50129279.p6510.06.2008, 10:5048