OKRA 06 - General Test Strip Information; Storage and Handling of Test Strips

OKRA OKRA
68
69
OKRA Pro test strips have the new bio-sensor technology, requiring only a tiny drop
of blood. OKRA Pro meter can store 365 readings in memory with date & time. All your
results are easily downloadable to your computer.
• Store the test strip vial in a cool, dry place between 36-86°F (2-30°C). Keep out of
direct sunlight. Do not freeze.
• Store test strips in its original vial only. Do not mix the test strips in new vials or in any
other container.
• Immediately replace the cap and close tightly after removing a test strip.
• Use test strip immediately after removing it from the vial.
• Do not use test strips after the expiration date. It may cause inaccurate results.
• Make a notation of the discard date when you rst open it.
• Discard any remaining test strips after 6 months of rst opening.
• Avoid getting dirt, food, and water on the test strip. Do not handle test strips with
wet hands.
• Do not bend, cut, or alter test strips in anyway.
General
Storage and Handling
Cautions and Safety Information section
• For in vitro diagnostic use only
• The single-patient use system is for single-patient use only and should not be shared.
• Not for neonatal use
• Do not use for diagnosis of or screening for diabetes mellitus.
• Not for use on critically ill patients, patients in shock, dehydrated patients or hyper-osmolar
patients
• Alternative site testing (AST) should only be performed during periods of steady-state blood
glucose conditions (when glucose is not changing rapidly).
• AST should not be used to calibrate continuous glucose monitors (CGMs).
• AST should not be used for insulin dose calculations.
• All parts of the kit are considered biohazardous and can potentially transmit infectious diseases,
even after you have performed cleaning and disinfecting.
• Always use a new, sterile lancet. Lancets are for single use only.
• Avoid getting hand lotions, oils, dirt or debris in or on the lancets and the reusable landing
device.
• Please refer to the Instructions for use for cleaning and disinfecting OKRA Pro glucose monitor-
ing system.
• Make sure to ll the strip with sucient amount of blood to avoid inaccurate result.
• Verify the meter code matches the code number printed on the test strip vial.