3-6
DRIVER (Driver Temperature): This knob regulates
the temperature for the entire vehicle when the PASS
knob is in the center neutral position. Turn the DRIVER
knob clockwise (toward red) to raise the temperature.
Turn it counterclockwise (toward blue) to lower the
temperature. The display will show your selection for a
few seconds, then it will show the outside temperature.
If you press the knob, the set temperature will again
be displayed for a few seconds, followed by the
outside temperature.
PASS (Passenger’s
Temperature): This knob
adjusts the air temperature
on the passenger’s side
to be warmer or cooler
than the temperature set
by the driver.
Turn the PASS knob clockwise to raise the temperature.
Turn it counterclockwise to lower the temperature.
The passenger side temperature will not be shown in
the display.
Off Button
Press the OFF button to turn the system off. The display
will show OFF and outside temperature.
Manual Control of the Automatic System
If you prefer to manually control the heating, cooling
and ventilation in your vehicle, set the system to the
temperature and fan speed you want. Next, press the
mode button to select the desired airflow direction. The
system will try to maintain the temperature you set using
the mode you select. The following suggestions will
help the system run more efficiently in manual mode.
(Fan): The button with the fan symbol and the two
arrows located below the display is used to manually
select the force of air desired. The display will show the
fan speed.
If the airflow seems very low when the fan is turned
to the highest setting regardless of the setting, your
passenger compartment air filter may need to be
replaced. See “Maintenance Schedule” and
“Passenger Compartment Air Filter” in the Index.
To Next Page
Loading...
Need help?
General
