3-7
MODE: The MODE button is used to control
the direction of airflow when the system is not in
AUTO. The first press will display the current airflow
direction. Repeated pressing of the MODE button will
cycle through the following airflow directions shown in
the display.
(Vent): This setting directs air through the
instrument panel outlets.
(Bi-Level): This setting directs air two ways.
Half of the air is directed through the instrument panel
outlets. Most of the remaining air is directed through
the floor ducts and a little to the defrost and side
window vents.
(Floor): This setting sends most of the air through
the ducts near the floor. The rest comes out of the
defrost and side window vents. When using this mode
and recirculation, the windows may fog up when the
weather is cold and damp. See “Recirculation” in the
Index for more information.
(Defogger): This setting allows half of the air to
go to the floor ducts and half to the defrost and side
window vents. The air conditioning compressor will run
automatically in this setting unless the outside
temperature is below 38
_
F (3.3
_
C). Even when the air
conditioning compressor is running, you can control the
temperature.
(Front Defroster): This setting directs most of the
air through the defrost and side window vents. Some of
the air goes to the floor ducts. The air conditioning
compressor will run automatically in this setting unless
the outside temperature is below 38
_
F (3.3
_
C). Even
when the air conditioning compressor is running, you
can control the temperature.
(Recirculation): This setting recirculates the
air inside the vehicle. This setting is not available in the
defogger or defroster settings. When operating the
system in the recirculation mode, the windows may fog
up when the weather is cold and damp. To clear the fog,
select either the defogger or defroster setting and
increase the fan speed. To avoid re
-fogging of the
windows, use the outside air mode.
(Outside Air): This setting brings outside air into
the vehicle.
To Next Page
Loading...
Need help?
General
