Removing the Stowable Seat
1. Remove the convenience center, if it is in the
vehicle. See
Convenience Center on page 2-58
for more information.
2. Make sure all items are off of the stowable seat.
3. If the seatback is down, put the seatback in its
upright position before removing the seat. See
“Folding the Seatback” previously in this section.
4. From behind the bench seat, push up the release
handles at the base of the seat to release the
latches from the floor pins.
5. While holding onto the crossbar at the bottom of the
seat, remove the seat by rocking it slightly toward
the rear of the vehicle and then pulling it out.
This should be done in one motion.
Notice:
If you use the release handles to remove the
seat, the handles could break, and the repairs would
not be covered by your warranty. Use the crossbar
located at the seat bottom to remove the seat.
1-20
To Next Page
Loading...
