PUSHBUTTONS:
The five numbered pushbuttons let
you return to your favorite stations. You can set up to
15 stations (five AM, five FM1 and five FM2). Just:
1.
Turn the radio on.
2.
Press
AM-FM
to select the band.
3.
Tune in the desired station.
4.
Press TONE to select the equalization that best suits
5.
Press and hold one
of
the five numbered buttons.
The sound will mute. When
it
returns, release the
button. Whenever you press that numbered button,
the station you set will return and the tone that
you selected will also be automatically selected for
that button.
the type of station selected.
6.
Repeat the steps for each pushbutton.
P
SCAN:
Press SCAN for more than two seconds, and
P SCAN will appear on the display. The radio will go to
the first preset station stored on your pushbuttons, stop
for a few seconds, then go
on
to
the
next preset station.
Press
SCAN
again to stop scanning.
Setting the Tone
BASS:
Press this knob lightly
so
it extends. Turn the
knob to increase or decrease bass. When you use this
control, the radio’s tone setting will switch to manual.
TREB:
Press this knob lightly so it extends. Then pull
the knob all the way out. Turn the knob to increase or
decrease treble. When you use this control, the radio’s
tone setting will switch to manual.
If
a station
is
weak or
noisy,
you
may want to decrease the treble.
Push these knobs back into their stored positions when
you’re not using them.
TONE:
This feature allows you to choose preset bass
and treble equalization settings designed for jazz, vocal,
pop, rock and classical stations. JAZZ will appear
on
the
display when you first press TONE. Each time you press
it, another setting will appear on the display. Press it
again after CLASSIC appears and MANUAL will
appear. Manual tone control will return to the BASS and
TREB knobs. Also, if you use the BASS and TREB
knobs, control will return to them and MANUAL
will appear.
3-12
To Next Page
Loading...
