FWD
(2):
Press this button to advance quickly to
another part of the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances. You may select stations
during FWD operation by using TUNE.
PROG
(3):
Press this button to play the other side of
the tape.
00
(4):
Press
this
button to reduce background noise.
Note that the double-D symbol will appear on the display.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol
are
trademarks of
Dolby Laboratories Licensing Corporation.
TONE:
Press this button to select a tone while playing a
cassette. The tone will be automatically set whenever
you play a cassette tape.
SEEK:
Press the up or down arrow to search for the
next or previous selection on the tape. Your tape must
have at least three seconds of silence between each
selection for SEEK to work. After
the
selection has been
playing for at least eight seconds, press the SEEK down
arrow to return to the beginning of the selection.
SCAN:
Press this button to listen to each selection for a
few
seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound will mute,
SCAN will appear on the display and the tape direction
arrow will blink while scanning.
AM-FM:
Press
this
button to play the radio when a tape
is
in
the player. The tape will stop but remain in the player.
TAPE
AUX:
If you have a tape inserted and the radio is
playing, press TAPE
AUX
to play your tape. To return
to the radio while a tape is playing, press
AM-FM.
The
inactive tape will remain safely inside the radio for
future listening.
EJECT:
Press this button to remove the tape. The
radio will play. EJECT may be activated with either the
ignition or radio
off.
Cassettes may be loaded with the
radio and ignition
off
if this button is pressed first. If
you leave a cassette tape in the player while listening
to
the radio, it may become warm.
CLN:
If
this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
3-14
To Next Page
Loading...
