3.
To
make the lap part tight, pull down
on
the buckle
end of the belt as you pull up on the shoulder part.
The lap part of the belt should be worn low and snug on
the hips, just touching the thighs. In a crash, this applies
force to the strong pelvic bones. And you’d be less
likely to slide under the lap belt. If you slid under
it,
the
belt would apply force at your abdomen. This could
cause serious or even fatal injuries. The shoulder belt
should
go
over the shoulder and across the chest.
These parts of the body are best able to take belt
restraining forces.
1-30
To Next Page
Loading...
