6.
To tighten the belt, pull up on the shoulder belt while
you push down on the child restraint.
7.
Push and pull the child restraint in different
directions to be sure it is secure.
To
remove the child restraint, just unbuckle the vehicle’s
safety belt and let it go back all the way. The safety belt
will move freely again and be ready to work for an adult
or larger child passenger.
Securing a Child Restraint in a Rear
Outside Seat Position (4-DoOr Models)
If you have a two-door model, see “Securing a Child
Restraint in a Rear Outside Seat Position (2-Door
Models)” earlier in this section.
You’ll be using the lap-shoulder belt. See the earlier part
about the top strap if the child restraint has one.
1.
Put the restraint on the seat. Follow the instructions
for the child restraint.
2. Secure the child in the child restraint as the
instructions say.
3.
Pick up the latch plate, and run the lap and shoulder
portions of the vehicle’s safety belt through or
around the restraint. The child restraint instructions
will show you how.
If
the shoulder belt goes in front of the child’s face or
neck, put it behind the child restraint.
1-43
To Next Page
Loading...
