Resuming
a
Set Speed
Suppose you set your cruise control at a desired speed
and then you apply the brake. This will shut
off
the
cruise control but you don’t need to reset it.
Once you’re going about
25
mph
(40
km/h)
or more,
you can move
the
cruise
control switch from
ON
to
R/A (Resume/Accelerate)
for about half a second.
You’ll go right back up
to your chosen speed and
stay there.
Increasing Speed While Using Cruise Control
There
are
two ways to go to a higher speed:
Use the accelerator pedal to get to the higher
speed. Push in the
SET
button, then release the
button and the accelerator pedal. You’ll now
cruise at the higher speed.
Move the cruise switch from
ON
to
R/A.
Hold it
there until you get up to the speed you want, and
then release the switch. (To increase your speed in
very small amounts, move the switch to
R/A
for less
than half a second and then release it. Each time you
do this, your vehicle will go
1
mph
(1.6
km/h)
faster).
The accelerate feature will only work after you set the
cruise control speed by pushing the SET button.
2-33
To Next Page
Loading...
