How to fix idle issues on my Oleo-Mac Brush Cutter?
If your Oleo-Mac Brush Cutter starts, runs, and accelerates, but does not idle, adjust the idle speed screw “T” (Fig.95, pag.52) clockwise to increase the speed. Refer to the carburetor maintenance chapter for detailed instructions.
What to do if my Oleo-Mac Brush Cutter engine doesn't start or stalls quickly?
If your Oleo-Mac Brush Cutter engine doesn't start or stalls shortly after starting, there could be two main reasons. First, there might be no spark. Check the spark plug for a spark; if there's none, try again with a new CMR7A spark plug. Second, the engine might be flooded. Follow the procedure on page 26 of the manual to resolve this. If it still doesn't start, try the procedure again with a new spark plug.
Why does my Oleo-Mac Brush Cutter engine lack power and emit smoke?
If your Oleo-Mac Brush Cutter engine does not reach full speed or emits excessive smoke, check the following: * Ensure you are using the correct fuel mixture of fresh gasoline and appropriate 2-stroke engine oil. * Inspect the air filter and clean it according to the maintenance instructions. * It may be necessary to have the carburetor adjusted by an Authorized Service Center.
Why won't my Oleo-Mac BC 280 accelerate properly?
If your Oleo-Mac Brush Cutter engine starts but doesn't accelerate properly or doesn't run correctly at high speed, the carburetor likely needs adjustment. Contact an Authorized Service Center to have the carburetor adjusted.
What to do if the cutting tool on my Oleo-Mac BC 280 isn't rotating?
If your Oleo-Mac Brush Cutter starts and runs, but the cutting tool doesn't rotate, the clutch, bevel gear, or drive shaft may be damaged. If necessary, replace the damaged components. Contact an Authorized Service Center for assistance.
Warning about the risk of hearing damage from noise exposure during operation.
Essential safety rules for operating the brush cutter, including personal protection.
Guidance on appropriate protective clothing and equipment for safe operation.
Safe procedures for handling and adding fuel to the machine.
Guide for starting the engine, including procedures for warm starts.
Troubleshooting steps if the engine becomes flooded.
Instructions on how to safely stop the engine after use.
Instructions for sharpening cutting blades and discs for optimal performance.
Procedures for maintaining and replacing the nylon line in the trimmer head.
Important warnings and procedures for maintaining the muffler and catalytic converter.
A detailed schedule outlining maintenance tasks and their recommended frequencies.
Guide to diagnosing and resolving common operational problems with the brush cutter.
General| Engine Type | 2-stroke |
|---|---|
| Displacement | 27.2 cm³ |
| Power Output | 0.8 kW |
| Weight | 5.9 kg |
| Cutting Width | 25 cm |
| Fuel Tank Capacity | 0.58 L |
| Sound Pressure Level | 96 dB(A) |
To Next Page
