Oleo-Mac BC 420 User Manual (English)

Questions and Answers:

X
xpattersonAug 10, 2025
Why won't my Oleo-Mac BC 420 Trimmer engine start or stay running?
- G
  Gregory TownsendAug 10, 2025
  If your Oleo-Mac Trimmer engine won't start or cuts off shortly after starting, there could be two main reasons: either there's no spark, or the engine is flooded. To fix this, first check the spark at the spark plug tip. If there's no spark, try again with a new BPMR7A spark plug. If that doesn't work, follow the procedure on page 28. If the engine still won't start, repeat the process using a new spark plug.
J
justinthompsonAug 17, 2025
Why does my Oleo-Mac BC 420 engine start then immediately die?
- H
  harrisluisAug 17, 2025
  If your Oleo-Mac Trimmer engine won't start or cuts off shortly after starting, it might be due to a lack of spark or a flooded engine. Check for a spark at the spark plug tip, and if there's none, try a new BPMR7A spark plug. Also, you can follow the procedure on page 28. If it still fails, try the procedure again with a new spark plug.
T
Thomas BowmanAug 25, 2025
Why is my Oleo-Mac Trimmer engine smoking and not running at full speed?
- D
  Dana AdamsAug 25, 2025
  If your Oleo-Mac Trimmer engine doesn't reach full speed or emits excessive smoke, it could be due to several factors. First, ensure you're using fresh fuel and the correct 2-cycle oil mix. Next, check the air filter and clean it according to the instructions in the Maintenance-Air Filter Section. If these steps don't resolve the issue, the carburetor may need adjustment.
L
Lisa ParsonsAug 31, 2025
Why does my Oleo-Mac BC 420 Trimmer engine emit smoke and lack power?
- J
  Jennifer WashingtonAug 31, 2025
  If your Oleo-Mac Trimmer engine doesn't reach full speed and/or emits excessive smoke, start by checking the oil/fuel mixture and ensure you're using fresh gasoline and the correct 2-stroke oil. Also, clean the air filter following the instructions in the Maintenance-Air Filter section. If the problem persists, the carburetor might need adjustment.