ENGLISH
EN - 20
4 -
MAINTENANCE AND CLEANING
Always make sure the appliance has been disconnected electrically before
proceeding with any maintenance or cleaning intervention.
Do not touch the metal parts of the appliance when you remove the lter.
There is a risk of injury due to the sharp metal edges.
Do not use water to clean the internal parts of the air conditioner.
Exposure to water can ruin the isolation, with the risk of electric shocks.
4.1 - CLEANING
4.1.a - Cleaning the appliance and the remote control
a. Use a dry cloth to clean the appliance and the remote control.
b. It is possible to use a cloth moistened with cold water to clean the appliance in case it’s very dirty.
Do not use a chemically treated or antistatic cloth to clean the appliance.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
4.1.b-Cleaningthesuctionlter
Inordertoguaranteeeffectiveindoorairltrationandgoodworkingorderofyourappliance,itisessentialto
periodicallycleantheairlters(13)every2weeks(inconditionsoffrequentuse)(Fig.9).
Operate as follows:
a. Openthefrontpanel(2)andthenslidetheltersout(13)(Fig.9).
b. Thelters(13)mustbewashedusingajetofwaterfacinginthedirectionoppositetothatoftheaccumulation
of dust or cleaned using a suction device (Fig.10).
c. Ifthedirtisparticularlydifculttoremove(suchasgreaseordepositsofothertypes)theltersmustbe
previously immersed in a solution of water and neutral detergent.
d. Beforere-introducingthelters,itisgoodpracticetoshakethentoeliminatethewateraccumulatingduring
washing.
If the lters (13) are damaged, replace them.
e. Makesurethatthelters(13)arecompletelydry.
f. Re-positionthelters(13)correctlyintherelativeseats.
g. Suckpossibleufffromthegrille(Fig.20).
Do not use the appliance without the lter (13).
To Next Page