What to do if my Olimpia splendid LIMPIA 2 Humidifier is not producing water vapor?
If your Olimpia splendid Humidifier isn't producing water vapor, try the following: First, unplug the power plug and then plug it back in. Second, if there was a power failure, wait for the power to return and try again. Also, ensure the tank is correctly attached. Finally, the surface of the ultrasonic disk may be dirty, so clean it.
What to do if my Olimpia splendid LIMPIA 2 unit has stopped working?
If your Olimpia splendid Humidifier has stopped working, it may be due to no or low water. Unplug the unit and refill the tank.
Why is my Olimpia splendid LIMPIA 2 Humidifier blowing air but not producing water vapor?
If your Olimpia splendid Humidifier is blowing air but not producing water vapor, it could be due to several reasons. First, there might be excessive water in the tank, so remove some of it. Second, detergent residue or oil ingredients from cosmetics might be in the tank, so wash it out and try again. Third, the ultrasonic disk could be dirty, so clean it. Finally, if you are using hard water, try replacing it with softer water.
What to do if water is accumulating around my Olimpia splendid Humidifier?
If water is accumulating outside your Olimpia splendid Humidifier, it could be due to saturation of humidity. Try lowering the mist control setting. Also, ensure the unit is on a level surface; if not, unplug it and place it on a level surface, pointing the spray away from objects. Raise the unit on a water-resistant level surface at least 60 cm from the floor.
Why are light symbols flashing on my Olimpia splendid Humidifier?
Flashing light symbols on your Olimpia splendid Humidifier indicate low water. Unplug the unit and refill the tank.
Why is the humidity level low with my Olimpia splendid LIMPIA 2 Humidifier?
If the humidity level is low when using your Olimpia splendid Humidifier, it could be that the surface of the ultrasonic disk is dirty, so clean it. Alternatively, the water in the unit might be too cold; replace it with cool, but not cold water.
Why does my Olimpia splendid Humidifier have a bad smell?
If your Olimpia splendid Humidifier has a bad smell, it's likely due to poor maintenance or dirty water. Clean the product thoroughly and fill it with fresh water.
Why is white dust forming on furniture near my Olimpia splendid LIMPIA 2?
If white dust is forming on furniture near your Olimpia splendid Humidifier, it may be due to hard water depositing dust. Use distilled water if this becomes a nuisance. Also, dust in the air also settles because of added humidity in the room.
How to reduce the noise level of my Olimpia splendid Humidifier?
To reduce the noise level of your Olimpia splendid Humidifier, ensure the unit is placed on a flat, level, hard surface. Make sure it is NOT placed on a soft or absorbent surface.
Why is water dripping when I refill my Olimpia splendid Humidifier?
If water is dripping when refilling your Olimpia splendid Humidifier, it's likely due to water remaining on the bottom of the tank. Wipe the tank or tilt it to drain before transporting.
Covers safe handling of electrical appliances, child safety, and precautions against damage or unauthorized repair.
Ensures correct placement, avoidance of heat sources, water damage, and electronic interference.
Details safe operation, water handling, cord care, and maintenance procedures to prevent damage or injury.
Do not use hot water, avoid direct sunlight, use clean water, and do not use chemical additives.
Use the touch button to turn the unit on/off, enabling or disabling vapour emission and night light.
Troubleshoot issues with no water vapor by checking power, tank attachment, and cleaning the ultrasonic disk.
General| Product color | White |
|---|---|
| Integrated timer | Yes |
| Water tank capacity | 2 L |
| Evaporation technology | Ultrasonic |
| Timer duration (maximum) | 8 h |
| Air purification capability | No |
| Dehumidifying capacity (min) | 3.6 l/24h |
| Suitable for room area up to | 25 m² |
| Suitable for room volume up to | - m³ |
| International Protection (IP) code | IPX0 |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 12 W |
| Quantity per master (outer) case | 4 pc(s) |
Weight and Dimensions| Depth | 189 mm |
|---|---|
| Width | 180 mm |
| Weight | 800 g |
| Package depth | 226 mm |
| Package width | 215 mm |
| Package weight | 1200 g |
To Next Page
