Olimpia splendid PELER 4D - Cleaning and Maintenance Guide

PELER 4D
ENGLISH
EN - 20
4.1 - CLEANING
4.1.a - Cleaning the appliance and the remote control
a. Use a dry cloth to clean the appliance and the remote control.
b. It is possible to use a cloth moistened with cold water to clean the appliance
in case it’s very dirty.
Do not use a chemically treated or antistatic cloth to clean the appliance.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic
surface.
4.1.b - Cleaning the lters
Operate as follows:
a. UseaPhillipsheadscrewdriver(notincluded)toremovethescrews(22)(g.N).
b. Removetheairlter(16)fromtheappliancebody(g.O).
c. Removethepaperlter(17)fromthebodyoftheappliance.
d. Cleanbothlters(16and17)withwaterandneutralsoap.Rinsethelters
well with clean water.
e. Ifnecessary,useasoftbrushtocleantheairltermoredeeply(16).
f . Lettheltersdry,thenreplacethemintothebodyoftheappliance(15).
g. Fixtheairlter(16)withbothscrews(22)(g.P).
Do not use the appliance unless the lters are properly installed. Do not
use the appliance if the lters are damaged or worn.