Olimpia splendid Unico EDGE - 3.3.3 - Controller Location; 3.4 - Remote Control Description; 3.4.1 - Remote Control Key Functions

UNICO EDGE R32
B1
B9
B8
B4
B5
B3
B11
B7
B2
B6
B10
B1
B5
B3
B8
B6
B4
B7
B12
B2
B11
42
43
T1
T2
EN - 23
ENGLISH
When replacing batteries, replace both and dispose of the dead batteries in the
appropriate collection centres and as required by law.
• Iftheremotecontrolisnotusedforseveralweeksorlonger,removethebatteries.
Any leaks from the batteries could damage the remote control.
• Theaveragelife-spanofthebatteries,withnormaluse,isapprox.sixmonths.Replacethebatterieswhen
theindoorunitcommandreceipt“beep”cannolongerbeheard,orifthetransmissionindicatoronthe
remotecontroldoesnotswitchon.
Do not re-charge or disassemble the batteries. Do not throw the batteries into the re.
They can burn and explode.
If the battery liquid falls onto the skin or clothes, wash well with clean water. Do
not use the remote control with batteries that have leaked.
The chemical products contained in the batteries can cause burns or other risks
to health.
3.3.3 - Location of the remote controller
• Keeptheremotecontrolinapositionfromwhichthesignalcanreach
theappliancereceiver(maximumdistanceisabout8meters-with
chargedbatteries)(g.31-32).
 Thepresenceofobstacles(furniture,curtains,walls,etc.)betweenthe
remotecontrolandtheappliancereducestheremotecontrolrange.
3.4 - DESCRIPTION OF REMOTE CONTROL
Theremotecontrolistheinterfacebetweentheair-conditionerandthe
customer,soitisveryimportanttolearnallitsfunctions,theuseofthe
variouscontrolsandthemeaningofthesymbolsmarkedonit.
3.4.1 - Description of the remote control keys (Fig.42-43)
B1 Activation/deactivation(Stand-by)oftheunit
B2 ECONOMY/ECO modekey
B3 Nightmodekey(SILENT)
B4 Operating mode selection
 -cooling>heating>ventilation>
 >dehumidication>automatic
B5 Increase/decrease fan speed
B6 Clock/programmingsetting
B7 Increase/Decreasedesiredtemperature/clock/programming
B8 Activation/deactivationoftheoscillationfunctionoftheairoutlet
ap
B9 Activation/deactivationoftheFREE COOLING airexchangesystem
(notavailableforthismodel)
B10 RESET key
B11 Activation/deactivationofprograms
B12 Selectionofthedesiredtemperatureunit°C/°Fby pressing
keys B7 simultaneously