Olimpia splendid Unico EDGE - 4 - Maintenance and Cleaning; 4.1 - Cleaning Procedures; 4.1.1 & 4.1.2 - Appliance & Air Filter Cleaning

EN - 32
ENGLISH
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning,
always make sure the system has been switched off, using
the remote control, and the power supply plug has been
disconnected from the system socket (or the upstream
master isolating switch is positioned at “0” OFF).
Do not touch the metal parts of the unit when removing the air lters.
They are very sharp. Cuts or injury risk.
4.1 - CLEANING
4.1.1 - Appliance and remote control cleaning
Useadryclothtocleantheapplianceandtheremotecontrol(g.33).
Itispossibletouseaclothmoistenedwithcoldwatertocleantheapplianceifitisverydirty.
Suckbetweentheairinletandoutletgrilles(g.34).
Do not use a chemically treated or antistatic cloth to clean the appliance.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
4.1.2-Cleaningtheairlter
Toensureeffectiveinternalairltrationandgoodairconditioningoperation,itisessentialtoperiodicallyclean
theairlterorwhentheLED A(red)onitlightsup.
Theairlterisatthetopoftheunit.
Filter extraction:
a. Electricallydisconnecttheappliance.
b. Switchofftheunitandwaitfortheclosureofthesuctionap.
c. Manuallyraisetheairsuctiongrille(3)(g.35).
d. Raisethefrontpartofthelter(F)andslightlypullittowardsyourself(g.35).
e. Extractthetwoadditionallters(g.36)fromtheltergroup(F):
 (greenpurifyinglterref.F1-blackactivecarbonslterref.F2).
f. Perfectlywashanddryallthelters.
Filter reassembly:
g. Inserttheactivecarbongroup (F2) ontheltergroup(F)lockingitonthespecialtabs (X1)(g.36).
h. Insertthepurifyinglter(F1)ontherstpinontheltergroup(X2),pullingitslightlyandlockingiton
theothertwopinspresent(X3)(g.36)
i. Reassembletheltersgroup(F1-F2)insertingtherearedgeinsidethegrid(g.37).
l. RManuallyclosetheairsuctiongrille(3)(g.37).
TodeactivatetheLED A(ifon),aftercleaningandrepositioningthelters,electricallyconnecttheappliance
thenpresstheresetkeyHbrieyusingapointedobject .
Inthisway,thesignalrelatingtotheneedforltercleaningisreset .