UNICO EVO R290
21
A
B
B
22a
E
E
L
EN - 23
ENGLISH
2.4.4 - Preparing the holes on the machine
If 162 mm pipes are being used, the removal operation of part of the rear cover must
not be performed.
In the event of use of Ø 202 mm holes, work as follows:
a. Use pincers to break the precut of the rear cover (g. 21-A).
b. Then, rotate back and forth the part of the cover to be remove with the hand until
breaking the remaining precut part (g. 21-B).
c. Use a cutter to trim the possible insulating material in excess which remained
inside the hole (g. 21-B).
Working on the two previously drilled holes
(see g. 6), x the support bracket (L) to the
wall using the supplied wall plugs screws
(H) (g. 22a).
After checking:
that the xing bracket is well anchored
to the wall,
that the installation site has been
prepared for electrical connection and
condensation discharge (if necessary),
it is possible to hook the air conditioner.
2.4.5 - Positioning of the device on the anchor bracket
To Next Page
Loading...
