23
TROUBLESHOOTING
There is no power to the device.
Ensure that the Power Switch on the main unit is physically set to the ON position.•
Ensure that the AC adapter cord is securely connected to the player and the proper wall outlet.•
The device will not play the disc.
Ensure that a supported disc is loaded in the player label-side up.•
Ensure that the disc’s rating level does not exceed the player’s parental rating level.•
Ensure that the disc is not damaged or too dirty. •
Clean the disc or try another disc.Moisture may have condensed inside the player. Remove the disc and •
leave the player on for 1-2 hours and then try again.
There is no picture.
Ensure that the TV set has been powered on and is set to the correct AV mode. •
Ensure that the connections between the player and the TV are secure and correct.•
Check if the connection cables are damaged.•
The picture is noisy or distorted.
The disc may be damaged or dirty. Clean the disc or try another one.•
Reset your TV’s color system.•
Ensure that the player is connected directly to the TV (and not through a VCR, cable box, satellite
receiver, etc.)
•
The picture is not full-screen.
Change the aspect ratio setting of your player from the Setup menu.•
Select a different aspect ratio option from the DVD disc menu.•
There is no sound or distorted sound.
Ensure that the TV and amplifier have been turned on and properly set up.•
Ensure that the TV and amplifier connections are secure and correct.•
Try a different Audio track of the DVD by pressing AUDIO.•
Ensure that the MUTE function of the TV, Amplifier, or Player is not engaged.•
• Place the DVD on the allocated space on the disc drive, and gently push the disc down until it is locked in
firmly by the three plastic clips on the rotating spindle in the middle.
To Next Page
Loading...