changing cord exit position
M3PRO
project iron
™
read all instructions before starting
if cord is damaged or cover does not close properly, stop and contact customer service
important safety instructions
Before beginning conversion make sure the iron is cold and unplugged from the outlet, and empty of water.
If the cover does not fit snugly back in place, remove and check cord is in the right place.
Be careful when fastening the cover in place not to trap the cord between the retainer as it could damage
the cord.
Reassemble the cover completely and secure the screws before plugging the iron into the outlet again.
Only use the original parts of the iron to reassemble, do not substitute or modify the parts in any way, or add
additional parts or material to the iron.
Be careful to not damage the power cord with the tools. If damage occurs stop and contact oliso customer service.
Be careful not to overly twist the cord when moving.
Ensure cord is fully under retainer before closing the cover.
We recommend changing the cord exit position only once.
1
2
3
4
5
6
7
8
9
To Next Page
Need help?
General
