Need help?Do you have a question about the Oliver 2019 and is the answer not in the manual?
Covers essential safety practices for operating the machine.
Outlines pre-operation safety checks and personal protective equipment.
Procedures for cleaning and securing the lathe after use.
Instructions and warnings regarding proper electrical grounding.
Guidelines for connecting the machine to a power source.
Covers space requirements, lighting, safety labels, dust control, and humidity.
Instructions for cleaning the lathe beds and machine oil.
Describes the buttons, dials, and readouts on the control panel.
Checks for proper alignment and securing of centers and tool rest.
Tests motor operation, direction, speed control, and overload protection.
Covers material selection and workpiece inspection.
Details how to inspect wood blanks for foreign objects and damage.
How to set the spindle direction and start the lathe at low speed.
Instructions for attaching a blank to the faceplate.
How to set spindle direction and speed for face grain turning.
Describes what a catch is and how to avoid it.
A table outlining maintenance tasks and their recommended intervals.
Lists possible causes and solutions for the machine failing to power on.
Addresses issues related to overload protection and circuit breakers.
Explains why the machine might stall and how to fix it.
Solutions for when the machine unexpectedly stops while running.
Diagnoses and solutions for excessive vibration or noise.
To Next Page
General