Page | 54
The top display now shows the time-schedule on 00:00 and on the last value set.
Press the SET button to access the modify mode and use the POWER + and
POWER - buttons to choose to change the hours or the minutes. Changing these
values is done by pressing the TEMPERATURE + and TEMPERATURE - buttons. Should
you wish to reset to zero the time-schedule intervals chosen, press the
LIGHTING/UNLOCKING button.
In order to save the settings chosen, press the SET button.
Now you can proceed to enable the programming. Press the
TIMERTHERMOSTAT/ESC button for several seconds, approximately 4, until the
daily led goes on.
" In order to complete the programming it is necessary for at least one
programming band to have its on time and its off time set, that will
indicate the moments for the product to be turned on and off.
" After having set the time-schedule intervals, in order to activate the
programming it is essential to proceed to enable it (operation of the daily
led being lit).
Press the TIMERTHERMOSTAT/ESC button to exit the daily timer menu at any time
without saving the changes made.
i The minutes scroll from fifteen to fifteen. By just setting the hour at 23 it is
possible to select for the minutes the value 59 so as to be able to make a
programming to straddle two days. In this case, it is necessary to set the
off hour of the first day at 23:59 and the on hour of the next day at 00:00.
To Next Page