5. INSTALLATION INSTRUCTION
51
Electrical Shock Hazard
Disconnect electrical power before installing dishwasher. Failure to do so could result in death or electrical shock.
Attention: The installation of the pipes and electrical equipments should be done by professionals.
Electrical requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate power
supply. Use the required fuse 10A/13A/16A, time delay fuse or circuit breaker recommended and provide separate
circuit serving only this appliance.
Electrical connection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate. Only insert the
plug into an electrical socket which is earthed properly. If the electrical socket to which the appliance must be
connected is not appropriate for the plug, replace the socket, rather than using a adaptors or the like as they
could cause overheating and burns.
Ensure that proper earthing exists before use
For personal safety:
• Do not use an extension cord or an adapter plug with this appliance.
• Do not, under any circumstances, cut or remove the earthing connection from the power cord.
About Power Connection
Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly
in place. If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear. This precaution is needed to avoid the risk of the water inlet to be blocked and
damage the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The system guarantees its intervention by blocking the ow
of water in case of the supply hose breaking and when the air space between the supply hose itself and the
outer corrugated hose is
WARNING
A hose that attaches to a tap can burst if it is installed on the same water line as the dishwasher. If your sink has
one, it is recommended that the hose be disconnected and the hole plugged.
To Next Page
Loading...