olson OLDW60X - Saving Energy; Starting A Program; Changing The Program Mid-cycle; Forget To Add A Dish?

73
NOTE
The ECO program is suitable to clean normally soiled tableware, that for this use, it is the most efcient program
in terms of its combined energy and water consumption, and it is used to assess compliance with the EU
ecodesign legislation.
1. Pre-rinsing of tableware items leads to increased water and energy consumption and is not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and water in the use phase than
hand dishwashing when the household dishwasher is
Saving Energy
1. Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the lower
basket rst, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page”Product che”. Make sure that the water
supply is turned on to full pressure.
4. Close the door, press the Power button.
5. Choose a program, the response light will turn on. Then press the Start/Pause button, the dishwasher will start
its cycle.
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow the
instructions below:
1. Press the Start/Pause button to pause the washing.
2. After the spray arms stopped working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start/Pause button, the dishwasher will start.
A program can only be changed if it has been running only for a short period of time, otherwise the detergent
may have already been released or the the wash water with detergent has already been drained. If this is the
case, the dishwasher needs to be reset and the detergent dispenser must be relled.
To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stopped working, you can open the door
completely.
2. Press Program button more than three seconds the machine will be in program selection mode.
3. You can change the program to the desired cycle setting.
Starting A program
Forget To Add A Dish?
Changing The Program Mid-cycle