Toll Free 1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com
Page 24
49. Standing on a ladder from the inside, position and
attach Part Z - Vent Hinged Window to Ridge Board.
50. Prior to attaching, confirm Window can move up and down freely and is centered evenly on
Rafters. When satisfied with location, attach Vent Hinged Window to Ridge Board with 3 - 3/4” black
screws per hinge.
51. Locate Part X - Roof Polygal Windows -
21 ” wide x 51” long. Peel protective plastic layer off
first sheet noting correct side out. Fit Window in dado
of Outside Rafter and gap of inside Rafter as shown
above.
Middle Rafter
To Next Page
Loading...