4. Position end of joist equally on one side of the
Core Block. Angle screw with 3 - 3” screws from
the top and sides. Joist and top of Core Block
should sit flush with each other.
Note, Drill 1/8” pilot holes in joist prior to screwing
to prevent splitting.
5. Lay completed Core Block / Joist Assembly on
flat level surface.
6. Position and angle screw the
second joist assembly to opposite
side of Core Block.
7. Continue to add Joist Assemblies to
Core Block.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com
Page 5
To Next Page
Loading...