Olympia A 210 - Setting Up Safely and Putting Into Operation; Laminating

Seite 20
Setting Up Safely and Putting Into Operation
Setting Up Safely and Putting Into Operation
IMPORTANT! Prior to starting up, check that the voltage
specications of the laminator correspond to that of your
power supply network (220 V - 240 V, 50 Hz).
1. Set the laminator down on a level, stable working surface close to an
easily accessible power socket.
2. Pay attention that the On/O switch
5
is set to OFF.
3. Connect the laminator's power plug
4
to an easily accessible power
socket.
Laminating
During hot lamination, the laminating pouch is heated to a temperature
of up to 105°C as it passes through the laminator rollers. This creates a
permanent thermal bonding of the laminated material and the laminating
pouch. Hot lamination permanently prevents the laminated material from
coming into contact with water, oxygen and bacteria.
WARNING! Risk of injury due to the feed mechanism.
Loose items could get caught in the infeed and cause injuries.
Keep ngers, hair, scarves, ties, jewellery etc. well away from
the feed side.
1. Switch the On/O switch
5
to ON.
2. The drive motor for the rollers starts up. The optimum operating
temperature is reached after 3 to 4 minutes.
The temperature control indicator
2
lights up red continuously.
WARNING! Risk to health through harmful vapours.
Vapours which are damaging to health can develop during
lamination. Always ensure good ventilation during lamination.
G