Olympia IC 600 - Connecting the Camera - Network Cable; Connecting the Camera

16
IP CAMERA IC 600
GENERAL OVERVIEW
Connecting the Camera - Network Cable
Connect the network cable to the network connection porton the
camera and a free network connection port (LAN) on the router.
A condition for putting the camera into operation is the
unambiguous identication of your camera within your
network. If you have not altered the default setting of your
router, this will occur automatically. In the case of most
routers, the DHCP function is activated at the factory. More
detailed information on the DHCP function is provided in the
operating manual supplied with your router.
Connecting the Camera
1 Connect the power cable to the power connection port and a
properly installed power socket.
One LED on the network connection port signals when a
connection exists to the network (lights up orange) and the
other that data is being transmitted (ashes green).