Olympia IC 600 - Troubleshooting

22
IP CAMERA IC 600
APPENDIX
Troubleshooting
My camera is not detected within the network.
Check all the cable connections. Observe the information in Section
"Connecting the Camera".
Check the network settings. The DHCP function must be activated in
the router. Your camera can only be found automatically in the net-
work when the DHCP function is switched on.
Reset your camera to its default factory settings. Use a thin object to
press in the opening on the rear of the camera for approx. 10sec-
onds. Ensure that the user identier and password correspond to the
default settings.
My camera is detected within the network but I cannot access it.
Check the entries for the user identier and password. The default
settings are provided on the rear of the camera.
Reset your camera to its default factory settings. Use a thin object to
press in the opening on the rear of the camera for approx. 10sec-
onds. Ensure that the user identier and password correspond to the
default settings.