Olympia PMR 1410 User Manual

14
use. Unauthorised modication or reconstruction
is not permitted. Under no circumstances open the
device or complete any repair work yourself.
Inserting the Rechargeable Batteries
Before the walkie-talkies can be used, insert the
batteries contained in the walkie-talkie package.
1 Remove the battery compartment cover. Slide the
battery compartment cover forward using a little
force.
caution!
Risk of explosion due to use of the wrong
types of battery! Only use rechargeable
batteries which comply with the specica-
tions in Section “Technical Data”. NEVER charge
standard batteries. Never mix the types of batteries
used.
2 Insert three appropriate batteries in the battery
compartment, paying attention to correct polarity.
3 Replace the battery compartment cover. The bat-
tery compartment cover latches audibly in place.
Charging the Rechargeable Batteries
You must charge the
rechargeable batteries
before they lose all their
power.
1 Connect the power
adapter to an easily
accessible power
socket in the vicinity.
2 Connect the power
adapter to the power
connection port in the
charging cradle.
3 Place the walkie-talkies in the charging cradle
unit. While the batteries are being charged, the
control lamps on the front of the charging cradle
light up red continually.
4 Remove the walkie-talkies from the charging
cradle after 8 hours.
5 Disconnect the power adapter from the power
socket.
Switching the Walkie-Talkies On
Press and hold the key for about 3 seconds.
The walkie-talkie is switched on, the display indicates
the selected channel
- , volume and
current battery capacity .
If only one bar is displayed, the batteries are
almost empty. Charge the batteries in good time.
Switching the Walkie-Talkies Off
Press and hold the key for about 3 seconds.
The walkie-talkie is switched off and the display goes
out.
Operating the Walkie-Talkies
When you want to communicate through the walkie-
talkies, you must switch the walkie-talkies on and set
them to the same channel.
To ensure a connection is established successfully,
the walkie-talkies must be within the reception range.
The elements selected in the menu ash when you
are dening the respective setting.
Sending and Receiving Signals
1 Press and hold the
PTT
key. appears in the
display. The walkie-talkie is in Transmit mode.
2 Hold the walkie-talkie close to your mouth and
speak into the microphone.

Olympia PMR 1410 Specifications

General

Brand	Olympia
Model	PMR 1410
Category	Two-Way Radio
Language	English