What to do if my Olympia TBL 1300 Combo stops working during operation?
If the Olympia laminator stops working during operation or after a longer period and the surface is hot, it's likely that the overheating protection has automatically switched it off. Wait approximately 30 minutes before attempting to laminate again. If it still doesn't work, contact our hotline.
Why is the laminated foil not completely transparent with my Olympia TBL 1300 Combo?
If the laminated foil isn't completely transparent when using your Olympia laminator, it's possible that the laminating temperature was too low. To improve the lamination, try laminating the same foil again.
How to fix POWER indicator if it does not light up on Olympia TBL 1300 Combo Laminator?
If the POWER indicator on your Olympia laminator does not light up, check the following: * Ensure the power plug is correctly plugged into the power socket. * Make sure the device is switched on by pressing the POWER button until the POWER LED lights up red. * If the issue persists, the POWER ON/OFF LED might be defective; contact our hotline.
Safety precautions specific to the laminator function, including hot surfaces and foil usage.
Safety precautions specific to the thermal binder function, including heat and object insertion risks.
Identification and description of physical controls and indicator lights on the device.
Detailed explanation of the function of control buttons and indicator lights.
Instructions for powering the device on and off.
Step-by-step guide for performing cold lamination.
Step-by-step guide for performing hot lamination.
Procedure for clearing jammed lamination foil from the device.
Step-by-step guide for performing thermal binding.
Explanation of the device's overheating protection (auto off) feature.
Instructions for cleaning the external housing of the device.
Procedure for cleaning the device's transport rollers.
To Next Page
General
