CORRECTING THE DATA
(for
QUARTZDATE/DLX
models)
1
.
Press
the
MODE
button
for two
seconds or longer.
2.
Press the mode button again to choose the
data to be corrected until it starts blinking. And
press the SET button
to correct the data.
The year indication will start blinking.
Note: As you press the mode button, the blinking indication changes in the order of year, month, day, hour, and minute. The data
correction will be finished when the mode button is pressed again.
If you press the button once, the number on display
will advance by 1. And if you keep it pressed, the
numbers will run through in rapid succession.
31
To Next Page
Loading...
