26
Chapter 1
Card basics (Cont.)
1
Make sure the camera is turned off;
● The monitor is off.
● The viewfinder is off.
● The lens is not extended.
2
Open the card cover.
3
Inserting the card
Insert the card as far as it will go in the
direction shown in the illustration.
● There is an arrow inside the card cover,
indicating the direction in which the card
should be inserted.
● Hold the card in a straight orientation to the
card slot. Do not attempt to insert the card at
an angle.
● Note the orientation of the card. If it is
inserted incorrectly, it may become jammed.
Removing the card
Hold the card with your fingertips and pull
it out in the direction of the arrow.
4
Close the card cover securely until it
clicks.
Inserting/Removing the card
● Never open the card cover, eject the card, remove the batteries, or
disconnect the optional AC adapter while the camera is in use or the
camera is communicating with a computer. Doing so could destr
oy all
data on the card.
● Destroyed data cannot be restored.
To Next Page
Loading...
