57
Chapter 4
Recording movies (Cont.)
3
Press the shutter button all the way to stop
recording.
● The card access lamp blinks and the camera
begins storing the movie on the card. You
cannot record another movie as long as the
card access lamp is blinking.
● When the card access lamp stops blinking,
the camera has finished writing the movie to
the card. If there is any space left on the
card, the number of seconds remaining is
displayed. You can start shooting another
movie.
● When the remaining time displayed has been used up, shooting stops
automatically and the camera starts writing the movie to the card. This
will happen regardless of whether or not you press the shutter button to
stop shooting.
● Shooting is not possible.
T Shooting is not possible while the camera is saving pictures to the
card. When the memory gauge goes off, you can take another shot.
TIPS
Card access lamp
● During movie recording, the flash and optical zoom cannot be used. To use
zoom, set DIGITAL ZOOM to ON (P. 59).
To Next Page
Loading...
