● Never open the card cover, eject the card, remove the batteries, or
disconnect an optional AC adapter when the card access lamp is blinking.
Doing so could destroy stored pictures and prevent storage of pictures you
have just taken.
Point the camera towards a
subject while viewing the monitor.
2
To focus on the subject, press the shutter
button halfway, slowly and gently.
● When the subject is in focus, the green lamp lights
up.
To start shooting, press the shutter button gently all the way
(fully).
● If the flash is up, it will fire automatically when required.
● The card access lamp blinks and the camera begins storing pictures on
the card.
Remove the lens cap. Set the mode dial to and
press the POWER switch.
1
3
4
Card access lamp
Green lamp
Flash switch
Power switch
Number of storable still pictures
Pressing the (monitor) button
turns off the monitor.
1 C725UZBasic-E1 04.2.19 1:42 PM Page 24
To Next Page
Loading...
