Press the shutter button halfway.
● When the subject is in focus, the green lamp
blinks once.
Press the shutter button all the way to start
recording.
● During movie recording, lights in red.
Press the shutter button all the way again to stop recording.
● The card access lamp blinks and the camera starts writing the movie to
the card.
● If the displayed seconds remaining reach “0”, shooting finishes
automatically and the camera starts writing the movie to the card.
3
4
5
Remove the lens cap. Set the mode dial to and press
the POWER switch.
1
Card access lamp
Power switch
Point the camera towards a
subject while viewing the
monitor.
2
Seconds remaining
AF target mark
1 C725UZBasic-E1 04.2.19 1:42 PM Page 25