10
Operating the MAUSB-10
The operating procedures for the MAUSB-10 under Windows are described below.
1 Connecting to the computer <98/98 SE/Me
⽧
Operation>
After installing the device driver, connect the MAUSB-10’s connector to the USB port on your computer. (You
can plug in the USB connector while the computer is in use.)
[Notes]
• Be sure to connect the MAUSB-10 to your computer AFTER installing the device driver.
• Make sure the connector is fully inserted.
• When inserting the connector, make sure it is oriented correctly (refer to the pictures below). Inserting the
connector incorrectly may damage the connector and/or the computer’s USB port.
USB port
(Type A)
The computer’s
USB port has a
mark over it.
To Next Page
Loading...