Olympus DS 30 Getting Started

b. S. Play (Slow Playback): Playback speed slows down, and S> will turn on.
(Default at .75 times as fast).
c. F. Play (Fast Playback): Playback speed becomes faster, and F>> will turn on.
(Default at 1.5 times as fast).
2. Even if playback is stopped the changed playback speed will be retained. The next
playback will be at that speed.
3. Note: Playback speeds cannot be switched when the Noise Cancel function is turned on.
How to Begin Segment Repeat Playback:
1. Play back the file for a segment repeat playback.
2. Press the Folder / A-B button on the left below the screen at the point you want to start
segment repeat playback. End? Will flash on the display.
3. Press the Folder / A-B button again at the position where you want to end segment repeat
playback.
a. The “Play” message appears, and repeat playback will start. The recorder
repeatedly plays back the segment until the segment repeat playback is canceled.
4. Press the OK or Stop buttons to release segment repeat playback and stop playback.
Noise Cancel Function
1. While the recorder is stopped or during playback, press the Menu button for 1 second or
longer.
2. Press the + or – button to choose “Noise Cancel.”
3. Press the OK or >> button to begin the noise cancel setup process.
4. Press the + or the – button to choose between “High,” “Low,” and “Off.”
5. Press the OK button to complete the setup screen.
6. Press the Stop button to close the menu.
7. You will notice a letter “N” above the battery on the screen, when the Noise Cancel
Function is properly selected.
Erasing
1. Press the Folder button to choose a folder.
2. Press the + or – button to choose the file you want to erase.
3. Press the Erase button.
4. Press the + button to choose “Erase.”

Olympus DS 30 Specifications

General

Built-in microphone	Yes
Maximum recording time	66 h
Display type	LCD
Battery type	AAA
Dimensions (WxDxH)	117 x 16 x 37.5 mm
Number of batteries supported	2
Internal memory	256 MB

Weight and Dimensions

Weight	80 g