Olympus FC-WR - Configurable functions; Safety Precautions

28
EN
Confi gurable functionsConfi gurable functions
indicates the default setting.
EV step: You can change the adjustment increment for #+/- (fl ash
compensation/fl ash intensity).
1/3 / 1/2
Back light mode: You can set the back light of the control panel.
Auto (The back light turns on during operation.) /
On (The back light is always on.) / Off (The back light is always off.)
Back light timer: You can set when to turn off the back light of the control
panel.
You can select the time (in seconds) until the back light turns off automatically
when there is no operation.
From 1sec to 5sec to 15sec
Safety Precautions
Read WARNINGS and CAUTIONS thoroughly to ensure safe usage. These
safety precautions protect the users and others and prevent property damage.
WARNING
Failure to observe the precautions indicated by this symbol
may result in injury or death.
• Do not use fl ash in places where it may be exposed to fl ammable or explosive
gas. Otherwise, fi re ignition or explosion may result.
• Do not directly solder the product or modify, remodel, or disassemble.
• Do not cover the light emitting area of the fl ash with your hand, and do not
touch the light emitting area after continuous fi ring. It may burn your skin.
• Water and foreign matter inside of the device may cause fi re or electric shock.
If the device is immersed in or exposed to water or foreign matter is found
inside of the device, turn off the power immediately and remove batteries with
care. Contact your dealer or consult an Olympus Authorized Service Station.
• To prevent a traffi c accident, do not direct the fl ash at a person operating a
motor vehicle.
• Do not use the fl ash or AF illuminator in close proximity to others (especially
infants). Keep the fl ash out of reach of children. Light from the fl ash can cause
visual impairment.
• To prevent a short circuit, do not use batteries with a damaged external seal
(insulation coating).