14
En
Self-Timer
1 Press NY to select [Y] and press i.
2 Press the shutter button completely to take the
picture.
The self-timer lamp lights for approximately 10 seconds
after the shutter button is pressed, then starts blinking.
After blinking for approximately 2 seconds, the picture
is taken.
Power Save Feature
To save battery power, the camera automatically enters sleep mode and stops
operating if not used for approximately 3 minutes. Press the shutter button or
zoom lever to reactivate the camera.
If the camera is not operated for 15 minutes after the camera enters sleep mode,
it automatically retracts the lens and turns off. To resume operation, turn on the
power again.
Se
-T
mer Lamp
d4326_oai_e_basic_00_bookfile.book Page 14 Friday, July 21, 2006 11:26 AM
To Next Page
Loading...
