CORRECTING THE DATA
Press
the
MODE
button
for two seconds or
longer.
Press the mode button again to
choose the data to be corrected
until it starts blinking. And press the
SET button
to correct the data.
The year indication will start blinking.
If you press the button once, the number on display
will advance by 1. And if you keep it pressed, the
numbers will run through in rapid succession.
Note: As you press the mode button, the blinking indication changes in the order of year, month, day, hour,
and minute. The data correction will be finished when the mode button is pressed again.
41
To Next Page
Loading...
