• However, there is no guarantee
that interference will not occur
in a particular installation. If
this equipment does cause
harmful interference to radio or
television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the
receiving antenna.
- Increase the separation between
the equipment and receiver.
- Connect the equipment into
an outlet on a circuit different
from that to which the receiver is
connected.
- Consult the dealer or an
experienced radio/TV technician
for help.
- Use only Olympus' supplied
cable or AC adapter when
you connect the applicable
equipment to an external device
or a power outlet.
FCC CAUTION
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
This transmitter must not be co-
located or operated in conjunction
with any other antenna or
transmitter.
This equipment complies with FCC/
IC radiation exposure limits set forth
for an uncontrolled environment and
meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement
C to OET65 and RSS-102 of the IC
radio frequency (RF) Exposure rules.
This equipment has very low levels
of RF energy that are deemed to
comply without testing of specific
absorption ratio (SAR).
For customers in USA
Declaration of Conformity
Model Number: LS-P4/LS-P1
Trade Name: OLYMPUS
Responsible Party: OLYMPUS
AMERICA INC.
Address: 3500 Corporate Parkway,
P.O. Box 610, Center Valley, PA 18034-
0610, U.S.A.
Telephone Number: 484-896-5000
Tested To Comply With FCC
Standards
FOR HOME OR OFFICE USE
This device complies with Part 15
of FCC Rules and Industry Canada
licence-exempt RSS standard(s).
Operation is subject to the following
two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation of this
device.
For customers in CANADA
CAN ICES-3 (B)/NMB-3 (B)
For customers in Europe
The “CE” mark indicates
that this product
complies with the
European requirements
for safety, health, environment
and customer protection. CE-mark
products are for sale in Europe.
This symbol [crossed-
out wheeled bin WEEE
Annex IV] indicates
separate collection of
waste electrical and
electronic equipment in
the EU countries. Please do not throw
the equipment into the domestic
refuse. Please use the return and
collection systems available in your
country for the disposal of this
product.
This symbol [crossed-
out wheeled bin
Directive 2006/66/
EC Annex II] indicates
separate collection of
waste batteries in the EU countries.
Please do not throw the batteries
into the domestic refuse. Please use
the return and collection systems
available in your country for the
disposal of the waste batteries.
To prevent possible
hearing damage, do not
listen at high volume
levels for long periods.
Hereby, Olympus Corporation
declares that the radio equipment
type LS-P4 is in compliance with
Directive 2014/53/EU.
The full text of the EU declaration
of conformity is available at the
following internet address:
http://www.olympus-europa.com/
10
EN
To Next Page
Loading...
Need help?
General
Weight and Dimensions
